## ---- STARTING SCRIPT ---- ## G28 ; Home all axes G21 ; Set all units to millimeters M83 ; Switch to relative extrusion coordinates G90 ; Switch to absolute motion coordinates G1 Z5 F1500 ; Lift hotend G1 X40 Y15 F4000 ; Move to prime line start G1 Z0.32 F250 ; Lower hotend G1 X190 E35 F540 ; Slow prime G1 Z5 E-2 F1500 ; Retract & lift hotend M82 ; Switch to absolute extruder coordinates G92 E0 ; Reset extruder position M83 ; Switch back to relative extruder coordinates M220 S100 ; Reset speed multiplier M221 S100 ; Reset extrusion multiplier ; Define firmware controls SET_RETRACTION RETRACT_LENGTH=1 RETRACT_SPEED=20 UNRETRACT_SPEED=40 SET_VELOCITY_LIMIT MAX_ACCEL=3000 MAX_ACCEL_TO_DECEL=1000 SQUARE_CORNER_VELOCITY=4 SET_PRESSURE_ADVANCE EXTRUDER=extruder ADVANCE=0.05 SMOOTH_TIME=0.01 ## ---- ENDING SCRIPT ---- ## M104 S0 ; Disable hotend heater M140 S0 ; Disable bed heater G91 ; Switch to relative motion coordinates M220 S100 ; Reset feedrate multiplier M221 S100 ; Reset extrusion multipler G1 Z10 E-5 F1000 ; Lift hotend away from part G90 ; Absolute motion coordinates G1 X235 Y235 F3000 ; Park hotend G1 Z250 F1500 ; Lower bed to Z_max M84 ; Disable motors M106 S0 ; Disable layer cooling fan
Comments