Pasted

// "The Arduino Kick Starter" Project
// For ICStation.com's 2015 DIY competition
// See it in action: https://www.youtube.com/watch?v=lrRGC9Ypedc
// Code for Receiver Module
// by Ido Gendel, 2015
// Share and enjoy!
 
#include <VirtualWire.h>
 
const unsigned long DISPLAY_TIMEOUT = 5000;
 
byte charMap[14] = {0x00 /* None */, 
  0xFA /* 0 */ , 0x22 /* 1 */, 
  0xEC /* 2 */, 0xAE /* 3 */, 
  0x36 /* 4 */, 0x9E /* 5 */, 
  0xDE /* 6 */, 0x2A /* 7 */,
  0xFE /* 8 */, 0xBE /* 9 */, 
  0x7E /* A */, 0x5C /* F */, 0xD0  /* L */
};
 
uint8_t buf[VW_MAX_MESSAGE_LEN] = "";
uint8_t buflen = VW_MAX_MESSAGE_LEN;
 
byte currDigit = 0;
unsigned long lastChange = 0;
 
void setup()
{
    for (byte j = 3; j < 11; j++) {
      pinMode(j, OUTPUT);
      digitalWrite(j, LOW);
    }
  
    for (byte j = A0; j < A4; j++) {
      pinMode(j, OUTPUT);
      digitalWrite(j, HIGH);
    }  
  
    // Initialise the IO and ISR
    vw_set_tx_pin(A5); 
    vw_set_rx_pin(12);
    vw_set_ptt_inverted(true); // Required for DR3100
    vw_setup(2000);  // Bits per sec
 
    vw_rx_start();       // Start the receiver PLL running
}
 
byte getCharMap(const char c) {
  
  if ((c >= '0') && (c <= '9')) return charMap[c - 47];
  if (c == 'A') return charMap[11];
  if (c == 'F') return charMap[12];
  if (c == 'L') return charMap[13];  
  return charMap[0];
  
}
 
void drawNextDigit() {
  
  char cm;
  
  currDigit = (currDigit + 1) & 3;
  cm = getCharMap(buf[3 - currDigit]);
  PORTC |= 0x0F; // all digits HIGH (clear)
  
  PORTD = (PORTD & 0x07) + (cm & 0xF8); //  pins 3-7
  PORTB = (PORTB & 0xF8) + (cm & 7); // pins 8-10
  
  PORTC -= (1 << currDigit); // current digit LOW (show)
  
}
 
void loop()
{
 
    if (vw_get_message(buf, &buflen)) // Non-blocking
    {
       lastChange = millis();
    }
  
    if (millis() - lastChange < DISPLAY_TIMEOUT) drawNextDigit();
     else PORTC |= 0x0F; // all digits HIGH (clear)
    delay(1);
   
}