IRremoteInfo - by AnalysIR (http://www.AnalysIR.com/)
             - A helper sketch to assist in troubleshooting issues with the library by reviewing the settings within the IRremote library
             - Prints out the important settings within the library, which can be configured to suit the many supported platforms
             - When seeking on-line support, please post or upload the output of this sketch, where appropriate

IRremote Library Settings
=========================
RAWBUF: 101
Timer defined for use: Timer2
IR Tx Pin: 3
MCU Clock: 16000000
MCU Platform: ATmega328(P) / (Duemilanove, Diecimila, LilyPad, Mini, Micro, Fio, Nano, etc)
Mark Excess: 100 uSecs
Microseconds per tick: 50 uSecs
Measurement tolerance: 25%
Minimum Gap between IR Signals: 5000 uSecs
Arduino IDE version: 1.8.5
Debug Mode: OFF (Normal)

IR PROTOCOLS  SEND     DECODE
============= ======== ========
RC5:          Enabled  Enabled
RC6:          Enabled  Enabled
NEC:          Enabled  Enabled
SONY:         Enabled  Enabled
PANASONIC:    Enabled  Enabled
JVC:          Enabled  Enabled
SAMSUNG:      Enabled  Enabled
WHYNTER:      Enabled  Enabled
AIWA_RC_T501: Enabled  Enabled
LG:           Enabled  Enabled
SANYO:        Disabled Enabled
MITSUBISHI:   Disabled Enabled
DISH:         Enabled  Disabled
SHARP:        Enabled  Disabled
DENON:        Enabled  Enabled
PRONTO:       Enabled  (Not Applicable)

Notes: 
     - Most of the seetings above can be configured in the following files included as part of the library
     - IRremteInt.h
     - IRremote.h
     - You can save SRAM by disabling the Decode or Send features for any protocol (Near the top of IRremoteInt.h)
     - Some Timer conflicts, with other libraries, can be easily resolved by configuring a differnt Timer for your platform