/*
For a DIATONE 3x4 WS2812 LED Matrix, which is often used in FPV drone builds, it's usually controlled through flight controller firmware like Betaflight or Cleanflight, as they have built-in support for WS2812 LEDs.

However, if you want to control it using an Arduino or ESP32, you can use the Adafruit_NeoPixel library. The DIN (Data IN) pin is used to send data to the LED matrix.

In this code, replace LED_PIN with the pin connected to the DIN of your LED matrix, and LED_COUNT with the total number of LEDs in the matrix. This code will light up each LED in a random color and refresh every half a second.

Please note the Adafruit_NeoPixel library uses a considerable amount of dynamic memory, so be aware if your project has other memory requirements.

Here's an example of how to light up the matrix in different colors:
*/

#include <Adafruit_NeoPixel.h>

#define LED_PIN    2  // The pin your LED strip is connected to
#define LED_COUNT 12  // The number of LEDs in the matrix

// Declare our NeoPixel strip object:
Adafruit_NeoPixel strip(LED_COUNT, LED_PIN, NEO_GRB + NEO_KHZ800);

void setup() {
  strip.begin();           // Initialize the NeoPixel library
  strip.show();            // Initialize all pixels to 'off'
}

void loop() {
  // Make the LEDs show different colors
  for(int i=0; i<LED_COUNT; i++) {
    strip.setPixelColor(i, strip.Color(random(0,255), random(0,255), random(0,255)));  // Random color
  }
  strip.show();   // Send the updated pixel colors to the hardware.
  delay(500);     // Pause before next pass through loop
}