Pasted

volatile int resistorValue = 10;
volatile int timerValue = 0;
volatile byte STATE = HIGH;
 void setup()
{
  Serial.begin(9600);
  pinMode(A0, INPUT);
  pinMode(9, OUTPUT);
   // Enable internal pullup on INT0 / PIN2
  pinMode(2, INPUT_PULLUP);
  delay(1);
   // Disable all interrupts
  noInterrupts();
   // Configure timer
  TCCR1A = 0; // Turn off `Compare Output Mode`
  TCCR1B = 0; // Turn off `Timer`, Reset Clock
  TCNT1 = 0; // Reset `Clock Count`
   // Set the prescaler to 1024
  TCCR1B |= (1 << CS12) | (1 << CS10);
   // Set compare value (16 000 000 / 1 024)
  OCR1A = 15625 / 1000;
   // Configure interrupt to happen on falling edge
  EICRA |= (1 << ISC01);
   // Enable external interrupt 0 (pin 2);
  EIMSK |= (1 << INT0);
   // CTC = Clear Timer On Compare
  TCCR1B |= (1 << WGM12);
   // Turn on `Output Compare Interrupt`
  TIMSK1 |= (1 << OCIE1A);
   // Enable interrupts
  interrupts();
}
 void loop()
{
  delay(100);
  // Here goes nothing
}
 ISR(TIMER1_COMPA_vect) {
  timerValue++;
   if(timerValue >= resistorValue) {
    STATE = !STATE;
    digitalWrite(9, STATE);
    timerValue = 0; 
  }
}
 ISR(INT0_vect) {
  resistorValue = analogRead(A0);
}